Autostart AS-2660i TW-FM Installation Guide download pdf (Page 3)

AS-2300TW Installation Guide P. 3

INDUSTRY CANADA USER NOTICE:

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference that

may cause undesired operation of the device.

To reduce potential radio interference to other users, the antenna type and its gain

should be so chosen that the equivalent isotropically radiated power (EIRP) is not more

than that required for successful communication.

FCC USER NOTICE:

The manufacturer is not responsible for any radio or TV interference caused by

unauthorised modifications to this equipment. Such modifications could void the user’s

authority to operate the equipment.

Installation Points to Remember

♦ Make sure that vehicles equipped with an

automatic transmission do not start while in

any of the drive gears. If the vehicle starts

in gear, install a manual-transmission

remote starter instead.

♦ When installing a manual-transmission

product on a vehicle with a manual

transmission, always make sure that all

doors will get the unit out of ready mode.

switch the wire used so that it is triggered

by all doors.

♦ When installing a manual-transmission

product on a vehicle with a manual

transmission, make sure that the parking

brake and door switch contacts work

properly.

♦ When working on a vehicle, always leave a

window open.

♦ Never leave the keys in the car. Leave

them on a workbench with a window rolled

down.

♦ If possible, remove courtesy light fuse to

prevent battery drain.

♦ The

PROGRAMMING ASSISTANCE BUTTON (PAB)

The PAB is mounted on the side of the

module unit and fulfils the same function as

the hood-pin switch. The PAB will spare

installers the effort of getting out of the

vehicle to access the hood-pin switch. The

PAB works only when the hood is up.

♦ Inspect vehicle for any body damage or

electrical problems

♦ Always solder and tape all connections.

♦ Keep the antenna away from other types of

antennas (GPS/OnStar).

♦ Never install the control unit where it could

interfere with normal operation or obstruct

service technicians.

♦ Always use a grommet when running wires

into the engine compartment. Never run

wires through bare or sharp metal.

♦ Do not disconnect the battery on vehicles

equipped with air bags and anti-theft radios.

♦ Never ground the control unit to the

vehicle’s steering column.

♦ Make sure that all the switches and controls

operate properly.

♦ Verify that the vehicle starts and idles

properly.

♦ Make sure that all safety equipment is

installed: the valet button (if provided), the

hood switch and the warning label.

♦ When wiring in parallel, make sure you

isolate each connection with a diode in

order to avoid feedback and possible

damage.

Examples:

Wiring a clutch bypass and a

transponder module to the

GROUND OUT

WHEN RUNNING

wire: At the junction point,

where the

GROUND OUT WHEN RUNNING wire

“splits” and connects to each device, a

diode is inserted on each of these lines.

Multiple or separate door pin connec-

tions:

1 2 3 4 5 6 7 8 ... 23 24

Comments to this Manuals

No comments

Autostart AS-2660i TW-FM Installation Guide Page 3

Comments to this Manuals

Related products and manuals for Car alarm Autostart AS-2660i TW-FM