Autostart AS-2660i TW-FM Installation Guide download pdf (Page 17)

AS-2300TW Installation Guide P. 17

d. To decrease the pulse by 10 ms, press the TRUNK button.

5. To save the new settings: press LOCK and UNLOCK. If 3 chirps are returned the new

settings have been saved.

Adjusting chirp duration

Otherwise close the hood to cancel the changes.

For each timing change, the horn will chirp with the new settings, except in the

following cases:

• When the lower limit of 5 ms is reached, there will be a 1/4-sec. chirp.

• When the upper limit of 200 ms is reached, there will be a 3/4-sec. chirp.

A system reset will set the module back to the default values: 30 ms.

Testing

Before putting back the vehicle together, it is recommended to check that the system operates

properly. The following testing procedures should be used to verify proper installation and

operation of the system. Before testing, make sure that all connections are soldered and that the

unit is plugged in.

 Remote-start the engine and listen for starter drag. If the starter cranks for too long,

carry out another tach programming procedure.

 Hood switch shutdown. with the vehicle running under the module, open the hood; the

vehicle should shut down. If it does not shut down, check the hood pin-switch and its

connector.

 Brake shutdown circuit. With the vehicle running under the module, press and release

the brake pedal. The engine should shut down immediately. If the engine continues to

run, check the brake switch connection.

 OEM alarm control. Make sure the module is able to arm and disarm the OEM alarm (if

applicable).

 Door locks and trunk testing. Make sure each of these options respond to the

transmitter (if installed).

 Starter kill option. Sit inside the vehicle with all doors closed. Arm the vehicle, then try

to start the Engine with the key. They engine should not start. If the engine starts, rewire

the starter kill to reach proper operation.

 Valet mode. Make sure the module is able to properly enter and exit valet mode. When

setting the module into valet mode, pressing the

LOCK button will lock the doors without

activating the starter kill. (Refer to the user guide for further information on valet mode.)

 Idle mode. Make sure the vehicle properly enters and exits idle mode.

Most comebacks are the result of misunderstandings about how a product works or performs. Take

the time to properly explain all functions and features to the customers before they leave the

premises. Doing this will save time and money.

Closing Up

Use tie-wraps or screws to properly secure the module and keep the wiring away from any moving

parts such as the parking brakes or steering column shafts.

Mount all switches in good and accessible locations where they do not risk getting kicked or hit

accidentally.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Autostart AS-2660i TW-FM Installation Guide Page 17

Comments to this Manuals

Related products and manuals for Car alarm Autostart AS-2660i TW-FM