AUTOMATIC TRANSMISSION REMOTE STARTER AS-2300TW Installation Guide Notice The manufacturer will accept no responsibility for any electrical damage
The Programming Assistance Button (A.k.a. the PAB.) Mounted on the module, this button can be used from within the vehicle instead of the hood pin
AS-2300TW Installation Guide P. 11 1. Flash the hood pin switch (see page 9) – The parking lights will stay ON for up to 20 seconds. – Before the
P. 12 Installation Guide AS-2300TW In each function, once an option has been selected the parking lights will flash 1, 2, 3, 4 or 5 times (dependin
AS-2300TW Installation Guide P. 13 FUNCTION 4 – Engine Type and Cold Weather Mode OPTION 1 Diesel mode with 20-minute run time in cold weather mod
P. 14 Installation Guide AS-2300TW Multi-Level Features (default state) Basic Features (press the SHIFT button 1X) SHIFT ¾ LOCK:...
AS-2300TW Installation Guide P. 15 Option 3: Level 1 (requires pressing the SHIFT button 1X) Æ Customized features Level 2 (requires pressing t
P. 16 Installation Guide AS-2300TW Note: The L.E.D. follows the parking lights during the transmitter programming procedure. At any time, close th
AS-2300TW Installation Guide P. 17 d. To decrease the pulse by 10 ms, press the TRUNK button. 5. To save the new settings: press LOCK and UNLOCK.
Most comebacks are the result of misunderstandings about how a product works or performs. Take the time to properly explain all functions and feature
AS-2300TW Installation Guide P. 19 note that most OEM systems will NOT rearm the alarm while the engine is running, but will still lock the doors.
P. 2 Installation Guide AS-2300TW Table of Contents Introduction ...2 Included in the Kit ...
P. 20 Installation Guide AS-2300TW • Passive arming: the starter kill will arm automatically if it is not armed by remote within a 60-sec. delay.
AS-2300TW Installation Guide P. 21 Events playback The first four playback codes are start failure events. There is a pause after each event code i
P. 22 Installation Guide AS-2300TW Diagnostics – Parking Light Flash Table Flashes Description 1 • Doors locked, starter kill armed. • End of r
Programming Options MODE 1 * INDICATES DEFAULT SETTING FUNCTION 1 – Ignition-controlled door locks OPTION 1* Ignition lock DISABLED OPTION 2 Igniti
AS-2300TW Programming Options and Wiring Diagram
AS-2300TW Installation Guide P. 3 INDUSTRY CANADA USER NOTICE: Operation is subject to the following two conditions: (1) this device may not cause
P. 4 Installation Guide AS-2300TW When joining all door pins together to the door pin input wire of the module unit, each wire must be isolated w
AS-2300TW Installation Guide P. 5 Warning: at the ignition switch of certain vehicles, there may be more than one ignition wire for powering th
P. 6 Installation Guide AS-2300TW 12-Pin Accessories Harness Wire Colour Function Description 1 BLUE (–) Trunk / AUX 3 output 500 mA negative o
AS-2300TW Installation Guide P. 7 9 PURPLE (–) External Trigger The external trigger wire can be used for remote-starting the vehicle with an exte
P. 8 Installation Guide AS-2300TW 12 YELLOW (+) Glow-Plug input In diesel mode, this positive input will monitor the glow plug light: it will wait
AS-2300TW Installation Guide P. 9 2-Pin Harness Wire Colour Function Description 1 BLUE/ WHITE (–) N/A This pin is not used. Leave it empty. 2
Comments to this Manuals