Autostart AS-2660i TW-FM Installation Guide download pdf (Page 16)

P. 16 Installation Guide AS-2300TW

Note: The L.E.D. follows the parking lights during the transmitter programming procedure. At any

time, close the hood to end the tach-programming procedure.

Automatic Tach Programming

This simple procedure can replace the multi-speed tach programming procedure:

1. Make sure that all the connections are properly made and that the module is powered

up.

2. With the hood up (ground on the hood pin switch line), start the vehicle using the key.

3. Allow the vehicle to reach regular engine idle speed.

The parking light output from the module will activate when the vehicle starts and

shut off once a tach signal is detected.

4. Press the brake pedal and keep it down until you see the parking lights flash 5 times (If

the horn is configured, you will hear 1, 2 or 3 honks).

5. Shut down the engine. Tach programming is now complete.

Automatic tach programming

Tach Adjustments

After having programmed the tach you might need to adjust it (increase or decrease the idle

speed). In order to do so, you will need to follow these steps:

1- Flash the hood pin (see page 9)

2- Enter the programming centre (see page 10).

3- Press and hold the brake pedal

4- Press simultaneously the LOCK and UNLOCK buttons.

5- With the brake pedal still pressed,

a. Press UNLOCK to decrease the idle speed, or,

b. Press LOCK to increase the idle speed.

6- Once you have obtained the desired idle speed, press TRUNK to save the new settings.

The parking lights will flash five times. If the horn has been configured you will hear one

honk if the last button pressed was LOCK and two honks if the last button pressed was

UNLOCK.

7- Release the brake pedal and close the hood.

8- The adjustment is done.

Adjusting the tach

Horn Timing

Follow these steps to program horn confirmation:

1. Ensure that the hood is up and that the ignition is OFF.

• Hold the hood pin-switch down for 4 seconds.

• Release the pin-switch. The parking lights will come on.

• While the parking lights are on, immediately push and release the

pin-switch again. The parking lights will stay on for up to 20 seconds.

2. Press and hold the brake pedal, then simultaneously press the UNLOCK and START/STOP

buttons on the transmitter – the horn will chirp 5 times.

3. Release the brake pedal.

4. To change the timing:

a. To increase the horn pulse by 3 ms, press the LOCK button.

b. To decrease the pulse by 3 ms, press the UNLOCK button.

c. To increase the pulse by 10 ms, press the START/STOP button.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Autostart AS-2660i TW-FM Installation Guide Page 16

Comments to this Manuals

Related products and manuals for Car alarm Autostart AS-2660i TW-FM