Autostart AS-2660i TW-FM Installation Guide download pdf (Page 20)

P. 20 Installation Guide AS-2300TW

• Passive arming: the starter kill will arm automatically if it is not armed by remote

within a 60-sec. delay. Press UNLOCK to disarm.

• Passive arming with 3-minute timeout: the starter kill will arm automatically after

3 minutes.

Flashing LED

There are three options available regarding the flashing LED:

a) The LED flashes once the starter kill is activated (passive or active arming) and will

turn itself off once the user turns the key to the IGNITION ON position.

b) The LED is totally disabled and will not flash.

c) The LED will flash once the starter kill is activated but requires pressing the

UNLOCK

button to turn itself off. Failure to press the

UNLOCK button will make the LED flash

even if the key is in the

IGNITION ON position.

Resetting the Module

The module is equipped with a reset function that allows the installer to erase all transmitter codes

from memory and return all the programming options to the factory default values.

Resetting the module is not a required process. Most of the time, you can avoid resetting by fixing

the issue directly at the root of the cause.

1. Flash the hood pin switch (see page 9)

– Once inside programming mode, you have 10 seconds to complete the next step.

2. Press and release the break pedal 6 times (within 10 seconds from entering

programming mode).

3. The parking lights will flash 8 times to confirm resetting.

Resetting without a valet button

On some vehicles (such as BMW and certain Volkswagen vehicles), resetting will not work if the

brake pedal is pressed while the ignition key is not in the

IGNITION ON (RUN) position: you will need

therefore to hot-wire the brake pedal by manually jumping 12 V with a fused test lead at the brake

pedal switch.

1. Flash the hood pin switch (see page 9)

– Once inside programming mode, you have 10 seconds to complete the next step.

2. Press and release the valet button 6 times or more until the parking lights start to

flash.

3. The parking lights will flash 8 times to confirm resetting.

Resetting with the valet button

Events Logging

With this feature, the module will play back the last 4 start failure events codes via the parking

lights or L.E.D.

Events playback

Ensure that the hood is up, that the vehicle is not in valet mode and that the ignition is

OFF.

• Hold down the hood pin-switch for 4 seconds.

• Release the pin-switch. The parking lights will come on.

• While the parking lights are on, immediately push the pin-switch 3 more times.

The parking lights and L.E.D. will flash the five events stored in memory.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Autostart AS-2660i TW-FM Installation Guide Page 20

Comments to this Manuals

Related products and manuals for Car alarm Autostart AS-2660i TW-FM