Autostart AS-2660i TW-FM Installation Guide download pdf (Page 15)

AS-2300TW Installation Guide P. 15

Option 3:

Level 1

(requires pressing the SHIFT button 1X) Æ Customized features

Level 2

(requires pressing the SHIFT button 2X) Æ Multi car operation

Level 3 (requires pressing the SHIFT button 3X) Æ Basic features

Option 4:

Level 1

(requires pressing the SHIFT button 1X) Æ Basic features

Level 2

(requires pressing the SHIFT button 2X) Æ Customized features

Level 3 (requires pressing the SHIFT button 3X) Æ Multi car operation

Example: If the multi-level features were set to option 3, the setup would be as follows:

x Level 1 Æ Customized feature

x Level 2 Æ Multi car operation

x Level 3 Æ Basic features

The “Basic features” are now programmed as level 3 and therefore:

x To access the aux.2 feature, the user needs to press on the SHIFT button three (3) times

followed by the LOCK button.

x To access the status request feature, the user needs to press on the SHIFT button three

(3) times followed by the TRUNK button.

x To access cold weather mode, the user needs to press on the SHIFT button three (3)

times followed by the START/STOP button.

Tach Programming

About Tach Programming

If you press the START button before carrying out a tach programming procedure, the module will

make no attempt to start the engine and the parking lights will give 5 flashes.

In order to carry out tach programming, you may simply follow the automatic tach programming

procedure.

The module stores tach settings regardless of the procedure used at the time of tach programming.

All tach settings are cleared when the module is reset. A new tach programming procedure has to

be carried out only if the module is reset.

Multi-speed Tach Programming

Tach signals may vary from vehicle to vehicle. The module is designed to read a wide range of

tach signals produced by recent ignition systems. There is no necessary manual adjustment.

Nevertheless, a tach-programming procedure must be carried out every time a new module unit

is installed. This is because the tach signals of certain ignition systems

are sometimes too low or too high for the module, causing failed start-ups at various temperatures.

1. Flash the hood pin switch (see page 9)

2. Press and hold the brake pedal,

– And simultaneously press the LOCK and UNLOCK buttons on the transmitter:

– The parking lights will flash 4 times.

3. Start up the Engine and allow the vehicle to reach regular engine idle speed.

4. Once the engine is running idle, press the brake pedal and keep it down until you see the

parking lights output flash 5 times (If the horn is configured, you will hear 1, 2 or 3 honks).

– Release the brake pedal: tach programming is now complete.

Multi-speed tach programming

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments

Autostart AS-2660i TW-FM Installation Guide Page 15

Comments to this Manuals

Related products and manuals for Car alarm Autostart AS-2660i TW-FM