Autostart AS-2500 TW Owner's Manual download pdf (Page 167)

• Automatic equipped vehicles with optional Keyless

Enter-N-Go™ – If the start button is pushed once

while in park with the ignition off and driver’s foot on

the brake pedal, the vehicle will automatically crank

and start after the Wait to Start time has elapsed. If it is

desired to abort the start process before it completes,

the driver’s foot should be fully removed from the

brake pedal prior to pushing the start button again in

order for the ignition to move directly to off.

• If the engine stalls, or if the ignition switch is left ON

for more than two minutes after the “Wait To Start”

telltale goes out, reset the grid heaters by turning the

ignition switch to the OFF position for at least five

seconds and then back ON. Repeat steps 1 through 5 of

“Starting Procedure – Engine Manifold Air Tempera-

ture Below 66°F (19°C).”

Starting Procedure – Engine Manifold Air

Temperature Below 0°F (-18°C)

In extremely cold weather below 0°F (-18°C) it may be

beneficial to cycle the manifold heaters twice before

attempting to start the engine. This can be accomplished

by turning the ignition OFF for at least five seconds and

then back ON after the “Wait To Start” telltale has turned

off, but before the engine is started. However, excessive

cycling of the manifold heaters will result in damage to

the heater elements or reduced battery voltage.

NOTE: If multiple pre-heat cycles are used before

starting, additional engine run time may be required to

maintain battery state of charge at a satisfactory level.

1. If the engine stalls after the initial start, the ignition

must be turned to the OFF position for at least five

seconds and then to the ON position to recycle the

manifold heaters.

STARTING AND OPERATING 165

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 329 330

No comments

Autostart AS-2500 TW Owner's Manual Page 167