Autostart AS-2272 Installation Guide download pdf (Page 21)

Installation Guide P. 21

Starter Kill Arming Mode

Note: It can only be activated if button Ι is programmed as LOCK or UNLOCK button.

The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm

automatically) or Active Mode (so as to require the user’s intervention for arming). By default, the

Remote Car Starter is configured to Passive Mode.

¾ Passive mode:

• To arm the Starter Kill, press the

Ι button on the transmitter, OR

• In Passive Mode, the Starter Kill will also automatically arm 1 minute (by default) or 3 minutes

(if configured this way) after the ignition is turned OFF or once the last door is closed (if the

doors are monitored).

- The LED on the antenna will flash quickly during the countdown preceding the

activation of the Starter Kill.

- Once the activation countdown expires, the LED will send a series of quick double

flashes to indicate that the Starter Kill is now armed.

• To disarm the Starter Kill, press the Ι button on the transmitter.

- The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes

(if configured this way) if no door is left opened (if the doors are monitored) and the

ignition is not turned

ON.

¾ Active Mode:

• To arm the Starter Kill, press the

Ι button on the transmitter.

- The parking lights will flash once.

- The LED on the antenna will flash slowly.

- If remote door locks are installed, this will also lock the doors.

• To disarm the Starter Kill, press the Ι button on the transmitter.

- The parking lights will flash twice.

- The LED on the antenna will remain OUT.

- If remote door locks are installed, this will also unlock the doors.

Lock Pulse Duration

• Option 1: 7/10-sec. LOCK and 7/10-sec. UNLOCK pulses by default.

• Option 2: 4-sec. LOCK/UNLOCK pulses.

• Option 3: A single 7/10-sec. LOCK pulse and two ¼-sec. UNLOCK pulses.

Used for double-pulse Disarm/Unlock systems

Flashing LED

To gain access to this feature, make sure the Flashing LED option has been enabled at the time of

programming.

• Flashing LED ON: The LED will flash at all times (being passive or active arming) to denote

that the Starter Kill is active.

¾ Active arming: the LED flashes normally.

¾ Passive arming: the LED will flash at a faster rate during the countdown until the Unit

is armed, at which time the flashing rate will slow down.

¾ In Valet Mode: the LED will be on solid.

• Flashing LED OFF: The LED will not flash when the module is armed (passive or active

arming). However, if the module is in Valet Mode, the LED will remain

on solid when the Ignition is OFF.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Comments to this Manuals

No comments

Autostart AS-2272 Installation Guide Page 21

Comments to this Manuals

Related products and manuals for Car alarm Autostart AS-2272