Autostart AS-2272 Installation Guide download pdf (Page 14)

P. 14 Installation Guide

If no Glow-plug wire is found on the vehicle, the Glow-plug input on the module may be

“timed out”. The module will power up the Ignition and Glow-plug circuits and simply wait

for the time-out before starting.

Keeping the Glow-plug input wire of the module unconnected will hold the ignition

ON for

the preprogrammed delay.

Please program the tach before connecting the glow-plug input to the vehicle.

3-pin Harness

Wire Description

VIOLET/BLACK

N/A

LIGHT BLUE

(-) AUX 1 Output

500 mA negative output. Can be programmed for the following option:

• Horn confirmation on 1

press of the LOCK button.

WHITE/BLACK

(–) Parking lights

output

500 mA negative Parking Light output

Note: Ensure that the voltage does not vary when the dimmer control switch is turned up

or down. If this is the case, it is not the right wire.

There is also a positive Parking Light output. Only one of these two different

outputs needs to be connected.

Additional Ports

Port Description

Temperature

Sensor

(Optional)

N/A

RS-232 Port

For D2D connection; is used to interface bypasses and door locks convenience module

(check bypass list for compatibility and functionalities).

INV-200 Port Is used to interface the pulse inverter for door locks option.

Bypass/GPS Port

Is used for analog connection to some bypass units (check bypass list for

compatibility and functionalities).

Pager Port

Is used to connect an optional AS-200P pager (to use this option, make sure to program

pager option in Menu 3, Feature 5, Option 4).

Entering Programming Mode

This allows the installer to program the unit. Once the system is in programming mode, the installer

will have up to 20 seconds to select one of the sub-menus. If the installer fails to select a sub-menu

before the 20-second delay, the system will exit programming mode and the installer will have to

select again one of the 2 methods to get access to it.

Using the Hood Pin

Using the Antenna Programming Assistance

Button (A.P.A.B.)

• Press and hold the hood pin for 4 seconds. • Make sure that the hood is closed.

• Release the hood pin.

The parking lights will turn

ON.

• Turn the ignition key to the

IGNITION ON (RUN)

position.

• While the parking lights are ON, press the hood

pin once more and release immediately.

The parking lights will turn

ON and stay ON for

20 seconds.

• Within 5 seconds, press the programming button

on the antenna twice for 1 second each time.

The LED will come

ON solid.

• You now have 20 seconds to select one of the

sub-menus.

• You now have 20 seconds to select one of the

sub-menus.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Comments to this Manuals

No comments

Autostart AS-2272 Installation Guide Page 14

Comments to this Manuals

Related products and manuals for Car alarm Autostart AS-2272