Autostart AS-2272 User's Guide download pdf (Page 7)

User Guide P. 7

after its runtime has expired, secure lock will also rearm your factory security system and relock the

doors.

Remote Trunk Release

If your system was installed with the remote trunk release option, you can open your trunk by pressing

the Ι & ΙΙ buttons (simultaneously) on the remote transmitter. Vehicles must have an electric trunk

switch or a remote trunk button on the vehicle’s OEM transmitter for this option to be compatible with

the module.

Turbo Mode

If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user leaves

the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it is shut down

by remote control), then shut down the engine.

If your vehicle has an automatic transmission

, proceed as follows to set the system to Turbo

Mode:

1. With the engine running, make sure to release the brake pedal and press the buttons Ι & ΙΙ on the

transmitter until the parking lights come ON.

2. Remove the key from the ignition switch. The engine will continue running.

3. Exit the vehicle and close all doors, hood and trunk.

4. Press the buttons Ι & ΙΙ to lock the doors (the engine will shut down after 60 seconds).

Note: If your vehicle has a manual transmission, Turbo Mode can be activated only if button Ι is

programmed as LOCK or UNLOCK button. Turbo Mode is activated through the same routine as that

used for Ready Mode; at the last step, the button Ι is pressed.

Note: The vehicle will enter Ready Mode once the engine run time expires.

Engine Run Time

If you have a gas engine, your remote starter can be programmed to run the engine for 3, 15, or

25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be programmed

to run the engine for 8, 20, or 30 minutes (20 minutes default).

1 2 3 4 5 6 7 8 9

No comments

Autostart AS-2272 User's Guide Page 7