P. 4 User Guide
To set the system to Ready Mode:
If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the neutral
position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
2. With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3. Within 20 sec. of engaging the parking brake,
press and hold Ι or ΙΙ on the transmitter.
The parking lights will flash 3 times
quickly and remain lit.
-
4. Remove the key: the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press for approx. 1 second either button: Ι or ΙΙ.
Note: The vehicle will also enter Ready Mode once the engine run time expires.
Remote-starting
Press the ΙΙ button for approximately 1 second. The parking lights will come
ON to inform you that the
remote starter has received your signal. Approximately 5 seconds later, the engine will start. The
parking lights will remain
ON during the pre-programmed run time of the engine.
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and try to
start the engine again. If your vehicle is equipped with an automatic transmission, there will be 3 start
attempts before the system gives up.
Driving Off
With the vehicle running under remote control, press the button Ι to disarm the security system (if
button Ι is programmed as
LOCK or UNLOCK button). Enter the vehicle and do the following:
1. Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK position
while the engine is running. This will cause the starter motor to re-engage.)
2. Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Remote starter features
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors locked
while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take control of the vehicle (i.e. no Key in the Ignition
Switch) while the engine is running.
To leave the vehicle in Idle Mode if your vehicle has an automatic transmission:
1. With the engine running, make sure to release the brake pedal and press the ΙΙ button on the
remote control until the parking lights come on.
2. Remove the key and exit the vehicle. The engine will continue running.
3. Lock the doors if needed.
Note: The engine will continue running until the user re-enters the vehicle or until the expiration of the
engine run time.
(15 pages)
(25 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals